fiber optic lan components preliminary pin plus preamplifier hfd6x80-001 honeywell vcsel products preliminary features ? lc rosa hfd6180-001 ? sc rosa HFD6380-001 ? high performance gaas pin photodiode with separate transimpedance amplifier ? microwave ceramic package capable of 20ghz ? data rates from dc to 12.5gbps ? receive signal strength indicator (rssi) ? low bias currents and voltages the hfd6x80-001 is a high-performance gaas pin photodector packaged with a transimpedance amplifier designed to meet performance requirements for 10gbps data communication over multimode optical fiber. applications include ethernet, fibre channel and atm protocols. the optical assembly is designed to interface either 50 m or 62.5 m multimode fiber. to achieve the full operational bandwidth, it is recommended that the products component leads be attached to within 0.010? of the ceramic package with a controlled impedance path. the hfd6x80-001 incorporates a received signal strength indicator to facilitate optical link health monitoring.
fiber optic lan components preliminar y pin plus preamplifier hfd6x80-001 2 honeywell ? vcsel products division preliminary for application help: call 1-800-537-6945 absolute maximum ratings parameter rating storage temperature -40 to +85 c case operating temperature 0 to +85 c lead solder temperature 260 c, 10 sec. power supply voltage -0.3v to 5v incident optical power 0 dbm average, +4 dbm peak notice stresses greater than those listed under ?absolute maximum ratings? may cause permanent damage to the device. this is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operations section for extended periods of time may affect reliability. electro-optical characteristics (vcc=3.3v, ac coupled to 50 ? ? ? ? , 0 c 200 w 900 1200 1200 1800 1500 3000 ? rssi bandwidth p r =-12dbm 10 70 khz notes: 1. p r is the average optical power at the fiber face. 2. responsivity measured with source wavelength of 850nm, with light source modulated at 1000mhz. 3. bandwidth is measured with a small signal sinusoidal light source with ?12dbm average power 4. rms input referred optical noise equivalent power is obtained by measuring the rms output noise into an 7500 mhz, 4-pole bessel-thompson filter then dividing by the responsivity. 5. measured at the 50% level of output pulses. 6. rise/fall times are corrected for optical source rise/fall times. the corrected value is calculated as the square root of the difference of the squares of the measured differential detector output and the source. 7. value shown is with no external power supply filtering. improved performance can be obtained by using external filtering close to the power supply leads. 8. typical values represent measured data at 25 o c. notice the inherent design of this component causes it to be sensitive to electrostatic discharge (esd). to prevent esd-induced damage and/or degradation to equipment, take normal esd precautions when handling this pr oduct
fiber optic lan components preliminary pin plus preamplifier hfd6x80-001 for application help: call 1-800-537-6945 preliminary honeywell ? vcsel products division 3 recommended interface circuit for the hfd6x80-001 vcc 10 ? 10nf case ground data data hfd6x80 vcc 50 ? t-lines limiting amplifier or test equipment 10nf 100 ? rssi the 100 ? ? ? ? = == = resistor prior to the limiting amplifier is needed only when the input impedance of the amplifier is not 50 ? ? ? ? dc blocking capacitors must also be present at the tia outputs to avoid a large dc current which may damage the chip.
fiber optic lan components preliminar y pin plus preamplifier hfd6x80-001 4 honeywell ? vcsel products division preliminary for application help: call 1-800-537-6945 hfd6180-001 dimension in inches [mm]
fiber optic lan components preliminary pin plus preamplifier hfd6x80-001 for application help: call 1-800-537-6945 preliminary honeywell ? vcsel products division 5 HFD6380-001 dimension in inches [mm]
fiber optic lan components preliminar y pin plus preamplifier hfd6x80-001 preliminary 07/24/02 vcsel products honeywell inc. optoelectronics facility 830 east arapaho road richardson, texas 75081 helping you control your world 006697-1-en il50 glo 797 printed in usa printed with soy ink on 50% recycled paper order guide catalog listing description hfd6180-001 lc r eceptacle, 850nm pin plus preamplifier HFD6380-001 sc r eceptacle, 850nm pin plus preamplifier pinout number function 1vcc 2gnd 3 datan 4 datap 5gnd 6 rssi warranty/remedy honeywell warrants goods of its manufacture as being free of defective materials and faulty workmanship. commencing with the date of shipment, honeywell?s warranty runs for 18 months. if warranted goods are returned to honeywell during that period of coverage, honeywell will repair or replace wit hout charge those items it finds defective. the foregoing is buyer?s sole remedy and is in lieu of all other warranties, expressed or implied, including those of merchantability and fitness for a particular purpose . while we provide application assistance, personally and through our literature, it is up to the customer to determine the suitability of the product in the application. specifications may change at any time without notice. the information we supply is believed to be accurate and reliable as of this printing. however, we assume no responsibility for its use. sales and service honeywell vcsel optical products serves its customers through a worldwide network of sales offices and distributors. for application assistance, current specifications, pricing or name of the nearest authorized distributor, contact a nearby sales office or call: telephone 1-800-367-6786 (usa) 1-800-737-3360 (canada) +49 (0) 89 35813310 (germany) +65-580-3312 (singapore) +44 (0) 118 981 9511 (uk) fax 1-972-470-4326 (customer response center) 1-972-470-4549 (fax on demand) +49 (0) 89 3599971 (germany) +65 445 3033 (singapore) +44 (0) 118 981 7513 (uk) internet http://www. honeywell.com/vcsel vcsel@honeywell.com 1 pin 1
|
